www.ams.com/AS5013
Revision 1.11
17 - 32
AS5013
Datasheet - I睠 Registers
8 I睠 Registers
8.1 Control Register 1 (0Fh)
Note:   The values in Control Register 1, X_register and Y_res_int register are frozen when the I?/SPAN>C address pointer is set to 0Fh, 10h or 11h. 
This ensures that the Data_valid bit, X and Y values are taken at the same time. In order to get updated values from those registers, set
the address pointer to any other address.
Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Idle
Time base bit[2]   Time base bit[1]   Time base bit[0]    INT_disable
INT_function
Soft_rst
Data_valid
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R
Reset value: 1111 0000
Bit
Bit Description
7
0 = Low Power Mode
The measurements are triggered with an internal low power oscillator  the user can select between 8 different timings by
setting the low power timebase (Control Register 1 [6:4])
1 = Idle Mode (default)
A new measurement cycle is started after the I睠 ACK bit following the read out of the Y_res_int register 11h. The
readout rate and thus the power consumption is externally controlled by the host MCU.
6:4
Configure the time base of the automatic wakeup in Low Power Mode (see Table 5).
3
0 = Interrupt output INTn is enabled (default)
1 = Interrupt output INTn is disabled and is fixed to Hi-Z
2
0 = Interrupt output INTn is active 0 after each measurement (default):
- Automatically triggered in Low Power mode, depending on the time base chosen
- 450祍 after Y readout in Idle mode
The interrupt is cleared by the I睠 ACK bit after reading the Y_res_int 11h. In block read mode, the several other bytes
could be transferred before the interrupt is cleared.
1 = Interrupt output INTn is active 0 when the movement of the magnet exceeds the Dead Zone area (see Figure 16).
The Dead Zone area is set by registers Xp (Reg 12h), Xn (Reg 13h), Yp (Reg 14h), Yn (Reg 15h).
The interrupt is cleared by the I睠 ACK bit after reading the Y_res_int register 11h, and will be active 0 at the next
measurement if the magnet is still in the Detection Area. In block read mode, several other bytes could be transferred
before the interrupt is cleared when the Y_res_int register is read.
It is recommended to use this mode with the Low Power mode (Idle = 0), in order to wake up automatically a system
when the magnet has been moved away from the center. The polling time is set by the Low Power time base bit [6:4].
1
0 = Normal mode (default)
1 = Reset mode. All the internal registers are loaded with their reset value. The Control Register 1 is loaded as well with
the value 1111 0000, then the Soft_rst bit goes back to 0 (Normal mode) once the internal reset sequence is finished.
0
0 = Conversion of new coordinates ongoing, no valid coordinate is present in the X and Y_res_int registers. Reading
those registers at that moment can give wrong values.
1 = New coordinate values are ready in X and Y_res_int registers.
相关PDF资料
AS5115-HSST-500 IC ENCODER ROTARY 16-SSOP
AS5130-ASST-500 IC ENCODER ROTORY 8-BIT 16-SSOP
AS5132-HSST-500 IC ENCODER ROTARY 20-SSOP
AS5134-ZSST-500 IC ENCODER RPTARY 20-SSOP
AS5140H-ASST IC ENCODER ROTARY 10BIT 16-SSOP
AS5145B-HSST-500 IC ENCODER ROTARY MAGN 16-SSOP
AS5510-DWLT IC ENCODER MAGNETIC LIN 6-WLCSP
ATS137-PL-B-B IC HALL SENSOR SGL 25MA SIP-3L
相关代理商/技术参数
AS5013-IQFT-6000 制造商:AMS 功能描述:IC ENCODER HALL SENSOR 16-QFN
AS5013-QF_EK_AB 功能描述:AS5013 ADAPTER BOARD 制造商:ams 系列:- 零件状态:在售 传感器类型:霍尔效应 感应范围:- 接口:I2C 灵敏度:- 电压 - 电源:2.7 V ~ 3.6 V 嵌入式:- 所含物品:板 使用的 IC/零件:AS5013 标准包装:1
AS5013-QF_EK_DB 功能描述:AS5013, N40P112 EasyPoint? Series Interface, Hall Effect Sensor Human Interface Device (HID) Evaluation Board 制造商:ams 系列:EasyPoint?? 零件状态:过期 主要用途:接口,霍尔效应传感器人机界面设备(HID) 嵌入式:否 使用的 IC/零件:AS5013,N40P112 主要属性:模拟操纵杆,带 3 个按钮 辅助属性:USB 接口 所含物品:板,线缆 标准包装:1
AS50-150K-RC 制造商:ALLIED 制造商全称:Allied Components International 功能描述:Axial Shielded Inductors
AS50-151K-RC 制造商:ALLIED 制造商全称:Allied Components International 功能描述:Axial Shielded Inductors
AS50-152K-RC 制造商:ALLIED 制造商全称:Allied Components International 功能描述:Axial Shielded Inductors
AS50-153K-RC 制造商:ALLIED 制造商全称:Allied Components International 功能描述:Axial Shielded Inductors
AS50-180K-RC 制造商:ALLIED 制造商全称:Allied Components International 功能描述:Axial Shielded Inductors